Electronic Flame Control Ignition Module NG or LP Automatic Fire Pit Igniter
Automatic Outdoor Fire Feature Control System – Electronic Flame Control Ignition Module – Natural Gas or Propane – Automatic Igniter for Fire Pits, Fire Features, Outdoor Fire Bowls/Tables. 12 Volt System – Natural Gas or Propane. INCLUDES: Pilot Shield, Transformer 12V, Pilot Tubing, Thermocouple, Hot Surface Ignitor, Pilot Injector (LP), Pilot Injector (Nat), Pilot Burner, Main Valve, Pilot Valve, Ignition Control. COMPATIBLE WITH JANDY CONTROLLER. Minimum Inlet Pressure: 0.25 psi Nominal Operating Inlet Pressure: 7″ WC (NG) / 11″ WC (LP). Best Price Point Automatic Fire Feature Controller On The Market! The Weather Beater Electronic Control System is the ultimate control for outdoor fire features. Powered by a state of the art microprocessor, it provides safe and sure control of ignition and operation. Built to withstand harsh outdoor conditions, the Weather Beater constantly monitors your fire and will even relight it in the case unusually high winds or rain temporarily extinguishes it. Flame-tec uses commercial grade components to ensure years of trouble free operation and even includes on-board diagnostics to report on the units performance. Available for use with LP or Natural gas. Ask about our wireless Bluetooth controls that let you operate the unit from a smartphone or tablet. L – 5.5″ x W – 5.5″ x H – 4.5. Sealed Transformer with 120VAC plug. Neither snow nor rain nor gloom of night… May be the motto for the post office, but it applies to the Weather Beater equally well. This ignition and control module will perform through wind, rain, freezing temperatures, salt air and more. Powered by a state of the art microprocessor, the Weather Beater provides safe and sure control by sensing if the flame goes out, then relighting automatically. If for some reason the fire does not relight the module will safely stop the flow of gas. Weather Beater meets and exceeds all the latest standards for installation near water while oper- ating fire features up to 290,000 BTU. Simple on off operation can be controlled by your choice of switch, pool controller or optional remote control. Whatever fire pit or fire feature you choose, make sure the Weather Beater Electronic Control is at the heart of the system. Its small foot- print fits in most any application, while its abundant features insure maximum enjoyment and years of dependable service. The ROCS Automatic Outdoor Control System is NOT an approved appliance. It is intended to be applied to appliances and burner systems supplied by various manufacturers. The ROCS in- structions are supplemental to the appliance manufacturers installation instructions. Failure to follow the manufacturers instructions, in addition to the ROCS installation instructions could result in property damage, injury or death. It is the responsibility of the installation professional and end user to confirm that the ROCS Control System is approved and safe to be used on the applied appliance or burner system. Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1. The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electric Code, ANSI/NFPA 70 (if applicable). FOR OUTDOOR USE ONLY! WARNING: If the information in these instructions in conjunction with the appliance man- ufacturers instructions are not followed exactly, a re may result causing property damage, personal injury or death. Do not store or use gasoline or other ammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS. Do not try to light any appliance. Immediately call your gas supplier. Follow the gas supplier’s instructions. If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. WARNING: For use with Natural or Propane gas only. NO SOLID FUELS TO BE USED WITH THIS SYSTEM. WARNING: Placement of media glass, lava, stone, etc. MUST NOT cover the pilot assembly. WARNING: Check for gas leaks after installation is complete. WARNING: Inspect all components before installa- tion. If any parts are damaged, contact your supplier. Do not install damaged parts.
Comments are closed.